噴射沉積法制備Al-Zn-Mg-Cu-Zr合金的顯微組織與性能Microstructure and properties of Al-Zn-Mg-Cu-Zr alloy prepared by spray deposition method

采用噴射沉積技術制備Al-8.11Zn-2.01Mg-2.36Cu-0.12Zr(質量分?jǐn)?shù)，%)合金，并對其顯微組織和性能進行研究。結果表明：噴射沉積的沉積態合金為近等軸狀，且晶粒均勻細小，尺寸約為50 μm；對合金進行(470 ℃，24 h)均勻化處理、420 ℃熱擠壓(擠壓比為39)、(470 ℃，1 h)固溶處理、(140 ℃, 8 h)時效處理后合金具有優良的性能，合金的抗拉強度為730 MPa，屈服強度為700 MPa，伸長率為11%。合金在140 ℃時效過程中，時效10 min即形成GP區；時效8 h后，主要強化相為針狀的η''''-MgZn₂和球狀的Al₃Zr粒子；時效72 h后，針狀的η''''-MgZn₂亞穩相呈現為棒狀的η-MgZn₂穩定相。該噴射沉積法制備的合金表現出優異的強度和韌性，可廣泛應用于航天航空工業、汽車工業、軌道交通、船舶、電子電工等領域。

Al-8.11Zn-2.01Mg-2.36Cu-0.12Zr (mass fraction, %) alloy was prepared by spray deposition method, and the microstructure and relevant properties were studied in detail. The results show that uniform and fine equiaxed grains with grain size of about 50 μm appears in spray deposition casting ingot. After homogenization treatment at 470 ℃ for 24 h, hot extrusion at 420 ℃ with extrusion ratio 39, solution treatment at 470 ℃ for 1 h, and aging treatment at 140 ℃ for 8 h, the alloy achieves excellent properties: the tensile strength is 723 MPa, yield strength is 700 MPa, elongation is 11%. When the alloy is aged at 140 ℃, GP zones appear in the early state for 10 min, then η''''-MgZn₂?phase and Al₃Zr phase form as aged at 140 ℃ for 8 h and they are the main strengthening phases, as the aging time increases to 72 h, the meta-stable needle-shape η''''-MgZn_2?phase gradually grows into stable rod-shape η-MgZn_2?phase. The studied alloy exhibits excellent strength and toughness, and the alloy can be widely used in aerospace, automotive, rail transportation, marine, electronic, electrical fields.

全文下載：http://pan.baidu.com/s/1sj1cPtj