新聞資訊
TC17鈦合金片層組織球化行為的有限元模擬及驗證
發布人：上海艾荔艾金屬材料有限公司m.85978597.cn
更新時間：2015-08-31
采用有限元模擬研究等溫鍛造過程中TC17鈦合金片層組織球化行為。通過熱模擬壓縮試驗獲得熱變形過程中變形參數對該合金球化行為的影響。
TC17鈦合金片層組織球化行為的有限元模擬及驗證Finite element simulation and test validation of
globularization behavior of TC17 titanium alloy
采用有限元模擬研究等溫鍛造過程中TC17鈦合金片層組織球化行為。通過熱模擬壓縮試驗獲得熱變形過程中變形參數對該合金球化行為的影響。以Avrami方程為基礎建立該合金片層組織球化模型，并將其嵌入有限元模擬軟件(DEFORM-3D)，使其具有預測和模擬球化過程的功能。進行圓柱形工件等溫鍛造及其相應的有限元模擬實驗驗證所建模型的準確性。結果表明：經二次開發的軟件可準確地預測等溫鍛造過程中TC17鈦合金片層組織的球化行為。
The globularization behavior of TC17 titanium alloy
during isothermal forging procedure was studied by finite element simulation. On
the basis of the Avrami equation and thermo-simulation compression experiment,
the prediction model was established, and the model was merged into DEFORM-3D.
The isothermal forging of cylinder workpieces and corresponding simulation were
performed. The results show that the second development model can be used to
reasonably and precisely predict the globularization behavior of TC17
alloy.
以上資料由上海艾荔艾金屬材料有限公司提供，歡迎新老客戶來電洽購。
本文來自上海艾荔艾金屬材料有限公司http://m.85978597.cn，轉載請注明出處。
前一頁：TA18鈦合金管材織構的表征及測定
后一頁：關于抗戰勝利70周年紀念日放假通知