新聞資訊
欠時效態7150合金的高溫回歸時效行為
發布人：上海艾荔艾金屬材料有限公司m.85978597.cn
更新時間：2015-10-27
通過維氏硬度、電導率及拉伸性能測試和TEM觀察研究欠時效狀態7150合金的高溫回歸時效行為。
欠時效態7150合金的高溫回歸時效行為High-temperature retrogression behavior of?under-aged 7150 aluminum alloy
通過維氏硬度、電導率及拉伸性能測試和TEM觀察研究欠時效狀態7150合金的高溫回歸時效行為。結果表明：回歸過程對合金的硬度和電導率影響顯著。隨著回歸溫度的提高，回歸曲線上的谷值點變低，達到谷值點所需的時間變短；在190 ℃回歸超過30 min后，晶界析出相明顯粗化，并且斷開；經過(110 ℃，16 h)+(190 ℃，120 min)+(120 ℃，24 h)的三級時效處理后，合金的抗拉強度為595 MPa，屈服強度為565 MPa，伸長率為12.5%，電導率為21.9 MS/m。采用此三級時效制度，合金的電導率較高，強度損失較小。此三級時效處理具有較長的第二級高溫時效時間，適宜工業化操作。
The Vickers hardness, electrical conductivity, tensile properties testing and TEM were used to investigate the high-temperature retrogression behavior of under-aged 7150 aluminum alloy. The results indicate that the hardness and electrical conductivity are strongly influenced by retrogression process. The valley values of retrogression curves become lower and the time to reach the valley values becomes shorter with the increase of retrogression aging temperature. After retrogression at 190 ℃ for 30 min, the precipitates on the grain boundaries become coarse and are sparsely distributed. After (110 ℃, 16 h)+(190 ℃, 120 min)+(120 ℃, 24 h) aging treatment, the ultimate strength, yield strength, elongation and electrical conductivity of the alloy are 595 MPa, 565 MPa, 12.5% and 21.9 MS/m, respectively. The electrical conductivity of the alloy can be increased with less reduction in strength by this triple step aging treatment. This triple aging treatment is suitable for industry because of a relative long time of the second step aging.
以上資料由上海艾荔艾金屬材料有限公司提供，歡迎新老客戶來電洽購。
本文來自上海艾荔艾金屬材料有限公司http://m.85978597.cn，轉載請注明出處。
前一頁：擠壓工藝對ME20M鎂合金組織和力學性能的影響
后一頁：熱變形溫度對7085鋁合金組織和性能的影響