新聞資訊
Sm對AZ91D合金顯微組織與力學性能的影響
發布人：上海艾荔艾金屬材料有限公司m.85978597.cn
更新時間：2015-10-31
利用光學顯微鏡、掃描電子顯微鏡和X射線衍射儀分析鑄態和固溶態AZ91D-xSm(x=0~1)合金的組織和相組成，測試其室溫拉伸力學性能和沖擊韌性。
Sm對AZ91D合金顯微組織與力學性能的影響Effects of Sm on microstructure and mechanical property of AZ91D alloy
利用光學顯微鏡、掃描電子顯微鏡和X射線衍射儀分析鑄態和固溶態AZ91D-xSm(x=0~1)合金的組織和相組成，測試其室溫拉伸力學性能和沖擊韌性。結果表明：隨著Sm含量的增加，鑄態組織中不連續網狀β-Mg17Al12相發生破碎，數量逐漸減少，而小塊狀高熱穩定性新相Al2Sm數量逐漸增多；拉伸力學性能和沖擊韌性整體均逐漸提高，AZ91D-0.88Sm合金的抗拉強度σb、伸長率δ和沖擊韌性αnK分別達到230 MPa、15.5%和24 J/cm2；經固溶處理后，β-Mg17Al12相完全固溶于α-Mg基體中，只存在Al2Sm相；拉伸力學性能和沖擊韌性均明顯提高，但其提高幅度隨著Sm含量的增加而有所減緩。
The microstructures and phase compositions of as-cast and solution-treatedAZ91D-xSm (x=0-1) alloys were investigated by optical microscopy, scanning electron microscopy andX-ray diffractometry. Meanwhile, the tensile mechanical property and impact toughness at ambient temperature were tested. The results show that the discontinuous networkβ-Mg17Al12phase breaks and decreases gradually among the as-cast microstructure with increasing the Sm content. Meanwhile, small block Al2Sm new phase with high thermal stabilityincreases gradually.The tensile mechanical property and impact toughness on the whole are enhanced gradually. Tensile strength σb, elongation δand impact toughness αnKof AZ91D-0.88Sm alloy reach230 MPa, 15.5% and 24 J/cm2, respectively. After solution treatment, β-Mg17Al12phase dissolves into α-Mg matrix completely and Al2Sm phase still exists. The tensile mechanical property and impact toughness are enhanced obviously and the improving amplitude decreases slightly with increasing the Sm content.
以上資料由上海艾荔艾金屬材料有限公司提供，歡迎新老客戶來電洽購。
本文來自上海艾荔艾金屬材料有限公司http://m.85978597.cn，轉載請注明出處。